AquaPure FIrmware question

Jump to latest Follow Reply
pauloharris

pauloharris

0
Apr 9, 2015
20
Nashville TN
Aquapure SWG, my firmware is 02110A10, which if i understand correctly is program "A".
Remote controller unit shows "A" however when I open the controller panel and view the board it appears to be flashing "B".
Now I am CONFUSED..
Tested chlorine with the handy dandy WALMART test kit ......shows little to no chlorine
Pool is crystal clear

any assistance & advice is always appreciated.......
 
JamesW said:
What is flashing B?

Do you have pictures of everything?

Do you have a picture of the circuit board?
Click to expand...
James,
Thanks in advance. I have attached pictures... on the picture labled B immediately to the left of the white connection there are two lights "A" and "B". the "B" was flashng but of course it doesnt seem to be now. DUH
 

Attachments

  • B.jpg
    B.jpg
    97.4 KB · Views: 13
  • circuit board.jpg
    circuit board.jpg
    128.9 KB · Views: 12
  • remote controller.jpg
    remote controller.jpg
    68.8 KB · Views: 8
As long as the lights on the box are all good, it's probably working correctly.

The unit will give an error code if it stops working for most reasons.

You can check the amperage going to the cell if you have an inline ammeter or clamp ammeter.

You can test at the wires going to the cell.

It should be about 5 to 6 amps DC.
 

Aquapure 1400 121 Error

I got the 121 error on my FusionSoft a couple days ago. I cleaned the cell and the sensor and the cell ran fine for about a day. Not this morning, it is back. It is still producing chlorine I can see bubbles out of the returns and the display also says it is on. I think my salt may be a little...
www.troublefreepool.com www.troublefreepool.com
 

Enjoying this content?

Support TFP with a donation.

Give Support
JamesW said:
As long as the lights on the box are all good, it's probably working correctly.

The unit will give an error code if it stops working for most reasons.

You can check the amperage going to the cell if you have an inline ammeter or clamp ammeter.

You can test at the wires going to the cell.

It should be about 5 to 6 amps DC.
Click to expand...
thank you sir.... maybe i need go directly to #3
1. pull & clean generator
2. get water tested
3. be patient
 
  • Like
Reactions: JamesW
You need to get the chlorine up to full level without waiting for the cell.

Use liquid chlorine.

Do an OCLT and do a full SLAM if you don't pass the OCLT.

Get your own good fasdpd test kit.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply