Getting ready to order a new pool liner and not sure what size I should order for the wall. Last time I ordered a 54 and had a lot of excess so I thought it was a 48 but apparently that’s very rare to have a 33 x 48 so now I’m thinking my floor may have been too high. Also it was a GLI liner so it may not have been true to size. From the pictures what size do you think it is?
Time for new liner, what size?
- Thread starter nathanc03
- Start date
Can you get the exact measurement to the top of the wall itself and not the top of the top rail. If you say a 54" last time had excess them it's possible you could have a 52" pool. From angle of the last pic it's is kinda hard to see exactly where the measurement would fall on the wall itself. Also after any sand was added to the bottom that would also raise up the floor a tad. So that is why I'm wondering if maybe it isn't supposed to be 52" high.
It’s 52 to the bead receiver but 54 to the top of the wall. I’m starting to think someone has added 3-4in of sand to the floor plus the cove.
In the top picture where the tape is hooked, is the sand washed away like that everywhere? It seems like your sand level should be at the bottom of the white sheet metal and covering the frame below it. If this is the case then it looks like you need a 48" liner.
There are several 33' x 48" liner available where I recently found a liner for my 15' x 30' x 48" AGP. I found what I wanted and it happened to be on clearance and with a 25% off coupon I paid $200 plus $11 shipping for a $350 liner.
Above Ground Swimming Pool Liners - Free Gasket Set w/ Purchase - PoolSupplies.com
There are several 33' x 48" liner available where I recently found a liner for my 15' x 30' x 48" AGP. I found what I wanted and it happened to be on clearance and with a 25% off coupon I paid $200 plus $11 shipping for a $350 liner.
Above Ground Swimming Pool Liners - Free Gasket Set w/ Purchase - PoolSupplies.com