Yarzy's latest activity
-
YYarzy replied to the thread Question on setting up AqualinkD.Not a bad idea. I am guessing the one I remove temporarily would be the connection to my iAqaulink, correct? Can I run them both at the...
-
YYarzy replied to the thread Question on setting up AqualinkD.Yes, I think that is what I am asking. I do have two 4-port Red PCB connections on my board. Just so I am clear, you are saying that I...
-
YHi everyone, I am in the EARLY stages of trying to get AqualinkD running so I can connect, monitor, etc. with Home Assistant. I got the...
-
YYarzy replied to the thread No Flow caused by low temp/salt?.Yeah, the No Flow came back WITHOUT the hairnets so someone suggested putting it in recirculation mode and see if it goes away and it...
-
YYarzy replied to the thread No Flow caused by low temp/salt?.Well, as usual, the TFP to the rescue! I took out the hairnets 2-3 days ago and have not had the No Flow message pop up (at least when I...
-
YYarzy replied to the thread No Flow caused by low temp/salt?.Yeah, you bring up a good point, plus I think I oversized my filter for that exact reason when I did the equipment. I like to run the...
-
YYarzy replied to the thread No Flow caused by low temp/salt?.Yes, it was a brand new filter setup. When I close the pool, I completely disassemble the filter, wash it down COMPLETELY, soak if...
-
YYarzy replied to the thread No Flow caused by low temp/salt?.NEWDUDE! Back to the rescue! I am running at 1200 RPM which has not been an issue for 3 years now. Its so weird that it works, then it...
-
YHi everyone, I just opened my pool today and was just trying to get ahead of any issues. Long story short, we were having "No Flow"...