Recent content by YahooWahoo

This forum is the absolute best!!! I wrote my Pentair guy with this info. He came right out to look at it. Unfortunately, it isn’t just the cable, but it is a Pentair automation problem that is totally under warranty and he is now working on it. Thank you all. I am so grateful to have found TFP!

You are awesome! Yes, this is exactly what it shows. I can access the one communication cable at the pump side. I have disconnected and reconnected this without change. The other one is within the control panel. I am a tad nervous to disassemble for fear I will void warranties. Longest hold...

I was so excited to try this, but i don’t see advanced settings or speed/flow circuits on the control panel . The pump not communicating is pump address 1 and the one communicating is pump address 2. I wonder if they limited my functionality so I don’t screw it up?

I really appreciate your thoughtful reply, but I may not be wise enough to understand. Are you referring to the IntelliCenter panel? I don’t see a pump address or pump settings. The pump itself has pump settings and says pump 1. I am not smart enough to tell you more about my electrical connections.

Appreciate your thoughts. The “display inactive” is the jet pump. The pool pump should say the same but it doesn’t. I tried the reset for 10 seconds. I would love if there was a solution that simple. I am in pool mode

In search of guidance… any help appreciated. Pool is 2 months old with pentair IntelliCenter set up. Our power flickered on 7/3 and since then, the pool pump is not communicating with the automation. I can run the pool manually, but not in conjunction with the intellecenter (the display doesn’t...

I like it. Have a few of those in concrete that I can try.

Thanks. Still very new to this, so appreciate the guidance. Pentair intelleflo vsf, pentair triton 2 sand filter. Volume should not be an issue. We are on sand and enough above water table. Water cannot stand on our property. The issue is the holes made when water shoots out of the hose...

New pool owner. Just plastered 2 weeks ago. I have had to backwash a few times (assuming due to plaster residue). Initial output is still Smurf blue. Each time, I lay the hose flat, but the pressure shoots water an leaves a huge hole in the ground. My yard is sand with amazing drainage, but the...

Thanks. On it with the chlorine. Generally, how long does it take for the cloudiness to clear completely? As in, when should I be worried that I need to do something else? Super appreciate of this forum