Recent content by WCF

  1. W

    Replaced Jandy Aquapure 700 salt cell but still no chlorine production?

    Good point and well noted! I was in the middle of a series of SLAM treatments (following instructions on this forum)...and then the plaster repair tech drained the entire spa and acid washed the exposed surface, which should have got rid of all the algae? Either way I will do a overnight...
  2. W

    Replaced Jandy Aquapure 700 salt cell but still no chlorine production?

    Hi, Just measured the voltage and its 36V, very high. I'll read the literature and see if I can do some more troubleshooting before I cotnact the seller on ebay. Thanks again for your help! Regards, Wen-Chun
  3. W

    Replaced Jandy Aquapure 700 salt cell but still no chlorine production?

    Hello, I did add salt and now we're at about 3200ppm. Left the SWCG running at 25% overnight and still nothing. Will measure the voltages next.
  4. W

    Replaced Jandy Aquapure 700 salt cell but still no chlorine production?

    Thanks for the reply! I will up the salt level and if I still have problemsdo the tests you mentioned. Will report back shortly.
  5. W

    Replaced Jandy Aquapure 700 salt cell but still no chlorine production?

    Hi Herman, thanks for the reply. I did change the cable out with the SWCG.
  6. W

    Replaced Jandy Aquapure 700 salt cell but still no chlorine production?

    First of all, thank you all for this wonderful forum. I have been learning alot from reading your posts! Long story short...started doing maintenance on spa (installed 2018) during the pandemic. I could get decent levels of FC (2-3) by running the Aquapure at 15-20%. Have had on again off...
See more
Top Bottom
Back