Recent content by wagonmeister

Ping, I will look into that kit. FattyLumkin, I added 1 1/2 cup. Directions on the bottle label show that I should be adding 600g to raise by 30.

Thanks for the replies. I went back to the pool shop yesterday for another test. They brought up the low CYA being the reason for chlorine getting eaten up so fast. They sold me some "pro balance UV" to get the levels right. I understand the general consensus about pool shops, and have been...

Here are the previous two tests I did at pool store; 06-20-2017; FC; 0.1 CC; -- pH; 8,0 TA; 86 CH; 225 CYA; 3 06-21-2017 after raising Ta and lowering PH, and adding a cup of chlorine (added the night before) FC; 0,1 CC; -- pH; 8,1 TA; 142 CA; 235 CYA; 1 06-23-2017 been two days of putting 1...

Pool; ABG 15', 22000L Ive been trying to get my water levels straight for couple of weeks since opening my pool ( maybe 3 weeks ago). Ive been bringing my water to get tested at my local pool shop and things dont seem to be getting better. The water is clear and all levels appear to be fine...

This is definitely the case. He seems to have worked from one side to another instead of from center out. The installer has advised me to fill up the pool completely and that it may take the entire season to stretch into place.... Does this sound right?

It may seem "fine" but considering I am paying for a professional installation there are many things that point otherwise. It is a 15' pool, and the liner is off centered by several inches. All the stress of the liner stretching is on one side of the pool. Even visually you can see that the...

There's is no foam along the bottom. He added a bit of sand and put down a "felt-like" carpet under the liner. there is definitely a gab between the liner and bottom of wall. It's been 2 weeks sitting with a foot of water and it still has not stretched into position.

I've recently had a new Above ground pool j hook / u-bead liner installed in my 48", 15' above ground pool. Installed by a "professional" :mad:... In another thread I was wondering if the installer did an acceptable job. Liner doesn't touch around most of the circumference of the pool (where...

If any one else could chime in it would be really appreciated. I will give the installer a call back and want to have some more feedback. Im afraid he will just tell me that it will stretch. I just cant imagine the liner stretching at the bottom edge if there is already 1 foot of water in the...

There is a gap between liner and edge all around. Some places slightly more than others. Liner looks fairly well centered, however the seam of the liner isn't exactly at the edge of the wall/floor. At some places it is a few inches from the wall and others closer to the edge.

Hey everyone! New to the forum and seeking help. Just got a local pool company to install a new U-Bead liner on my 48" 15' above ground pool.I wasn't home when he installed it but i know he had a vacuum shop vac to install it. When I got home he had filled the water to 1foot above cove. I...