Recent content by videochick2003

I didn't see any bubbles or air pockets and he used half a tube of the glue....lol. I put it on a couple of stacked flat pavers to keep it out of the grass then stacked 3 more on top of it to make sure it got a good seal. I am going to let it cure for the 24 hours per the instructions then check...

Even with the rubber boot cut off of the outside?

Patched with a clear patch on the inside - - - Updated - - - I found the thread on how to cut the hole so I could reuse the old fittings. What completely baffled me was what to do with the extra hole so I could fill the pool up.

Yes I do but hubby cut one of the sleeves off and patched it with a clear patch on the inside with a clear patch.

This is the outlet hole on the new liner. (sorry such a bad pic, it's dark here)

This is the size of the inlet hole & outlet hole of my old liner.

Thank you for replying. Could I get either of those at the hardware store? I am new to all of this.

The inlet part I have is bigger than the hole that is there. I don't have a black plug to plug it with, I didn't buy the whole thing just a new liner) already had the frame, the pump w/ lines, skimmer, inlet & outlet pieces, plungers & lines from the 18 X 48 intex ultra frame setup. My older...

Hi all, I had an 18 X 48 Ultra Frame Intex pool last year that was second hand (was a pre-2014 liner) as a starter pool for my 11 year old son. This year I decided to replace the pool liner and ended up getting a new 20 X 48 ultra Frame liner to upgrade to a bigger pool since I already...