Recent content by Turbine Doc

Thanks for the reply Bob, the SWCG is no longer in service (note to self need to change signature information), parts to repair it cost as much as a new SWCG, since becoming a member here learning in/out of water chem have found proper "care & feeding/testing" are all that is really necessary...

Went to this link & still have some questions, is it beneficial to run a pumping interval say like 6 hrs on 6 hrs off logic being that it would allow for debris to settle to bottom for collection when vacuuming? Also I'm in Deep South on the MS Gulf Coast LOTS of sun, so I'm thinking preferred...

Did the checks of the tri cell, and harness all are good, no blockages, I will try jumpering tomorrow in the main panel across pins for the flow switch to see if the flow alarm remains,

Thanks for the replies folks, the love/hate is not me & the pool, it's the me being the one who has to "fix it" when chemistry goes out of whack, I spend too much time away and my wife tries but just does not "get it" when it comes to water chemistry, if the pool is clear then it's good to here...

Additionally in the introduction forum I was asked what my current water chemistry was: "jacked up" would be the operative word, after much rain with SWG down the chlorine was down and we are near the end of a battle with algae bloom, it's settling to the bottom this morning following a floc...

In this thread flashing-check-flow-t10282-20.html#p222003 which contains a lot of similar information and troubleshooting I posted this: Rather than water down that thread with my own issues which may be similar but are different; I decided to post here in an independent thread. This was...

Hot & Sticky tonight here in South Ms, after threatening to fill it (the pool) with dirt or make a fishing pond out of it, and be done with it, I decided to surf the web and find some assistance to a constant low flow issue with our DIG-220 SWG, I posted in the SWG forum have a look if you have...

Howdy all, I'm new to the site great info, I just downloaded the "pin-out" document, & went through the continuity & resistance checks of the tri-sensor and the harness. No problems found there, I don't think lack of flow is a real issue as the pool vacuum (Kreepy Krawley) is still able to...