Recent content by tspo

Ok, thanks. But I should be able to remove it with it still being in some water, which will save me time when I open it in the spring.

Very good to know. Thank you!. I need to figure out what I actually have. The pool company didn't give me much info. Thank you! Thank you! Just need to find what specific led bulb I need. Thanks again

Yes, they are color logic. The light itself is what I suspected as well. They aren't under warranty any longer and the company that installed them, I will never do business with again! I will have to drain the pool a bit more in the spring so it can be removed/replaced. Thank you everyone...

I have a Hayward light controller, with an Intermatic PX100 transformer. One of the three LED lights continuously blink different colors while the other two work properly. Pictures of light controller and transformer for reference. Does anyone have any ideas? Thanks in advance

That's what I'm thinking. I will have to do some research on that. I've never taken a pump apart before.

I actually completely cleaned the de filter and added new media. Same issue. The check valve shows the flow. I also have one coming out of the heater. It's about 60% which is what I'm expecting at the 10 lb of pressure in the tank. When it is running normally at 19 lb those check valves are...

Thank you, and yes, that is correct. I will try that. Same rpm. 2700 rpm last year and same this year. When i set it at a higher rpm (2850) the filter psi increases to roughly 15. Skimmer basket and Pump baskets are clear. I will try closing main drain and skimmer drain and see if that...

@ Signature has been updated. Here are my specs - 15k Gal - IG - vinyl - StaRite S7MD60 Filter (DE) - Hayward TriStar VS900 Pump - New Water 430 Chlorinator - Hayward Summit XL Heater (electric) Photos of setup attached as well.

Thank you @HermanTX. I will get that updated first thing tomorrow. I do have a variable speed pump and I have not completely taken apart the pump, rather, I just felt with my fingers. I will get my signature updated will all specs on current equipment.

Hello all, I am new to the trouble free pools. I got a pool installed last season. I have a de filter. I was getting roughly 19 lbs of pressure. At one point last year I got down to 10 and that was because I had pine needles stuck in the propeller of the pump. This year,. I am getting...