Recent content by tomtc

I already had a Davis weather station at my house so I simply added another sensor for the pool temp and hung it over the side about 3 feet down in the water (The sensor is waterproof). It is accurate to about 1/2 a degree.

So, the final determination on interfacing an Aqua Rite cholrinator to a Jandy Aqualink RS system with the newer version M or later firmware (used with the iAqualink, among other things) appears to be that the very early version of the Aqual Rite (mine is 1.04) can't do it because it did not...

My Aqua Rite is version 1.04 firmware and appears not to support emulation. I do not have anything like AL-x on the diagnostic display as I scroll through the options. I get what appears to be the following as I cycle through the diagnostic modes: Temperature Volts Amps Percent Chlorination...

Some routers require that they be specifically enabled to allow B connections... Perhaps there is a setting for that in the router menu?

My Goldline Chorlinator is fairly old (circa 2002) so it may not support that, but I'll give it a try and see. I'll report back! Thanks!

I don't know what that is or where to set it but the response I got from Hayward was: "The loss of control was done by Jandy our software had nothing to do with it so unfortunately there is nothing we can do from our end. The upgrade of the Jandy system is what caused the issue in communication...

Thanks for the information! I also discovered that apparently Jandy and Hayward got in to some kind of a ******* match and thus the new replacement Aqualink RS control board will no longer talk to my Goldline Salt Chlorinator over the Aqualink RS port in it. The Goldline used to be permanently...

I've had no luck in finding the actual installation manual for the IQ-900RS system board that I used to upgrade my Aqualink RS (and which is part of the iAqualink package since my system board was a very old version and had to be ungraded to control the VS-FHP pump that I bought at the same...

I've had no luck in finding the actual installation manual for the IQ-900RS system board that I used to upgrade my Aqualink RS (and which is part of the iAqualink package since my system board was a very old version and had to be ungraded to control the VS-FHP pump that I bought at the same...

I'm getting ready to upgrade my Aqualink RS system with the Jandy IQ900-RS iAquaLink Kit with RS PCB Upgrade and the VS-FHP2.0 pump, so this is helpful. Jandy would not send me the installation manual or a link to it since I was not a "pool professional..." Where did you get a copy of the...