Recent content by swloomis

getting dark out here will try that in the morning. Do not want to end up in my own emergency room. been accidentally defibbed once and that was enough. Thank you again for all your help.

yes, the screen on the pump does not respond in service mode. tried pushing all the buttons and nothing happens. The screen is dark. when the panel is in auto the screen on the pump lights up and states screen display not active.

it does not run in service mode, but when he cleaner comes on it runs for about one minute then shuts down. I will try the reset. I called leslies and have a technician coming out on the 13th to look at it and install a new actuator. Hopefully he can figure it out. The only thing I can think of...

The pump ran fine prior to the install, we had leslies install a heater, then the hand held remote took a dump right after that. They suggested the screenlogic system. then this problem happened after that. the pump is about 7 years old, 6/13/2015,it is a pentair intelliflo variable speed p/n...

The pump does not run, the system is on active mode, the pump display states display not active. The cable runs from the pump to a port inside the panel.

I just installed the screenlogic2 system and everything works except the pump. I set the schedules for the pump and cleaner and is will not kick on. The cleaner starts for about 30 seconds to 1 minute then shuts off. I cannot get the pump to run. What am I doing wrong?