Recent content by SteveTech

Yes, I kinda figured that which is VERY odd for a pool that is only 6 years old. I am going to get someone to look at it when it gets a little warner outside

Good afternoon everyone! So we had a week of VERY cold temp, and I had about 3-4 inches of ice up against the gun step (one other small spot as well) and the lip of the top step cracked off due to ice pressure. Is this something that is fixable? DIY or should I just go pro.. Not sure what...

Negative, I do not have a spa side remote. Is it needed? So when I say factory reset, it would be resetting EasyTouch at the panel, not ScreenLogic

G'afternoon all, I'm running into some oddities with the screen logic system, so I'd like to get some feedback. So what has happened so far every once in a while, a program would randomly start that is not on schedule. Such as SPA kicking in at 10 pm for no reason. Biggest issue is the lights...

Finally figured out why the SPA level was draining down slowly. The seal in the inlet valve was shot, once I replaced the waterway guts, problems was solved. NOW the level in the SPA drops to right below the grout below the spillway and stops which tells me the grout has been eaten away by the...

now I am pretty sure that SPA is a result of the plumbing trying to equalize. while the water was slowly going down in the SPA, after the above fix, I went over to the poolmiser and low and behold, you could hear the water draining in the overflow tube, which shows me that the pool water was...

I found a post from a while back from Jim that made me think for a min.. Since my check valves were replaced last year, this post gave me pause as I also have continual PH rising AND the return valve was about 80/20 Spa/pool. I made the actuator adjustment and now the SPA is fully closed in...

I replaced those last year with the hope that was the issue.. I am going to double-check again and make sure they are closed and clean.. The only other thing I can think of is the waterway value on the SPA return, I ordered a valve replacement.. the previous owner did not do ANY preventative...

Here's the pad. In the config, it runs and stops on daily unless we use the spa.

Alright, I got the pool up and running and I am getting to the water next. PH and CC are good for now. I had an issue last year, and my poolmiser would "band-aid" the issue. So here is the problem, every night when the pool filter ends its cycle, over the 8 hours it is stopped, the water in...