Recent content by SR71P52

Thanks for the suggestions. the expansion joint meaning the caulk like material between the coping and the cement patio? If so, that definitively needs to be replaced. Do you have any suggestions for that? I believe you are suggesting that water ingress could have happened in the area and frozen...

Hi all, had my pool re-plastered with gunnite around 12 years ago. I’ve noticed over the past few years that there been several raised spots, small “potholes” and crack type areas on the floor and walls. Have also noticed that the plaster under the coping has begun to fall apart in some areas...

It seems they are indeed the shorter Dwv couplings (pressure rated to 5psi according to the specs)… any ideas on the easiest way to fix this? Or if it needs to be fixed in the first place? I would need to somehow remove the couplings from the valves and unions to fix this without spending a ton...

Got the pump installed and it’s working great. However I’m pretty sure the store mis labeled the couplers I used and I’m not sure they are pressure rated… is this a big deal that would require re- plumbing?

Sounds good. I also learned that the superflo needs 10 inches of straight line on the suction end. My current setup has the pump directly up to the suction valve so I should have to move the pump. Moving the pump straight back would not leave room for the filter drain. Any suggestions on where...

Thanks! I was thinking of putting it on the horizontal run right after the heater. There should be just enough space there with the flow sensor and unit. Would that work?

Hi all! I have a 30k gallon in ground pool. I just bought a circupool Rj60+ and a Pentair superflo VS. I’m looking for advice on the best installation for these items. As well as anything else you may see that is incorrect or needs fixing on the pad. I’ve posted some photos below for reference...