Recent content by sjoshi

Pentair Intelliflow VSF. I have set it to 1700 rpm.. it revvs up to perhaps 2800 for maybe a minute, a gurgle from a pool return, and back to 1700.

Hi all, i have a problem that has escaped diagnosis so far. I have a very simple schedule -- pool, waterfall and spillway (from spa) run from 8 am to 8 pm every day.. this is what I confirmed via laptop version of Screenlogic (since the iphone app is sometimes flaky with schedule changes)...

I have this growth - Algae / fungus above the waterline in many parts of the pool. The itself pool is clear, combined chlorine zero. The Dolphin Pro does a great job to a few inches above waterline. How do i remove it best? Also if stuff falls into the pool as I scrape off, is that ok? First...

TY will check clock battery.

Will do. However, system does not start after a power failure. I have to restart the pump (will now use the reset button instead) and restart Screenlogic.

Reset worked this time, TY! Also my pump is VS and not VSF, my bad.

Yes I have screen logic. The system will not start on its own without pushing the button or via screenlogic but I will try one more time since you asked. Egg timer is set to off. The schedule you see here is a debugging schedule (I was checking if the new features added were playing a role...

Hi all, I am troubleshooting how my pool pump - VSF 3 turns on or off with Easytouch. Regardless of the programmed schedules, pump turns off (and the heater with it) after 12 hours. And yes, egg timer is set to off for the pool circuit. Pump display says Address 1 Display Not Active. This...

TY. I will need some additional automation, I dont have that flexibility yet.

Hi all, i am thinking of turning off a waterfall feature in the cooler months to reduce heat loss especially since i will be using a heat pump running round the clock. My question is this. Given that water in the pipe will stagnate, is there a recommended frequency to run it now and then to...

Looks like the Pentair Ultra Temp heat pump is set to trigger valve at minimum 30 gpm (or 29.5 if the Easytouch measurement was right). So will need to run at 30 gpm.. still not bad. Need to just test FC in a few days to make sure at really low settings like 5% output, the chlorine generator...