Recent content by shingo

I cover the pool at night with a solar blanket and I also have a heater, it get cold at night 50 usually, so I need a both the solar blanket and the heater

I have my saniclear 20 set at 5% currently and my FC vary between 4 and 5. I have had the water analysed and beside the FC everything is absolutely perfect. The pool is 13000 gallon. I feel like even if it says 5% it's generating at 100% Everytime I check the cell, the voltage and amp...

The SWG stop when there is no flow and resume when there is. I red the instruction manual, but it's not really specified. I guess I will have to do some testing.

In my jacuzzi saniclear 20 instruction, it says the adjustment is the % of time the unit will run. If the unit is set to 40% when the pump run 24 hours a day, does it mean that if I set it at 60% and the pump run 16 hours a day, it will have the same result? Also it won't impact the cell life...

I will test how low I need to go on the RPM to trigger the low flow, I think 1400RPM is probably keeping it safe, it's only 55000 BTU. Also, the schedule is like this : 8:00-10:00 3000RPM 10:00-12:00 2200RPM 12:00-23:00 1400RPM Between 23:00 and 8:00 the system is down, so when it restart...

Hi everyone, I recently bought a inground pool with heat pump and a 3 speed pump (starrite supermax VS) In my heat pump manual, it says it require a minimum flow of 15GPH and a maximum flow of 45GPH. It also state that a flow under 15GPH can cause damage on the unit. By default the RPM for the...

Good news, they admited the finish is sub par and they are proposing to sand the whole thing with a diamond blade. Do you think it's a good idea, if they go that route, what do I have to check for, I guess they have to seal it after they are done? Do they have to apply something so that it's...

Is there a way to redo the finish without removing everything? Maybe an epoxy or something like that?

I didn't know there was other type than broom finish for pool concrete sidewalk.

Hi, I have an inground pool under construction, the contractor told me the sidewalk finish is normal. I do not believe it meet industry standard, because I believe we shouldn't see all these trowel mark. should I fight this with the contractor?