Recent content by rusrasmussen

As a followup, after a discussion with Pentair, they said it appears the wrong board was put in the OCP, so they are sending a replacement.

I appreciate that. I will call them. I updated to 1.064 from the firmware off the site. I was seeing the same screens before the update. It said something about the 2.x firmware, but it was not available to download.

Rebooted a screens attached

I do not have a Configure Network section.

On the panel, I do not have an option to setup an account. I posted the image of what the app shows me which says of course to go to the OCP and create an account. But that option does not show up for me.

I've attached an image that shows I have the OCP panel, but I do not see the service option. And I have 900mhz high powered wireless link kit so there is no network or wifi setup info.

I'm not completely following you on the SWCG wiring. That was done previous to me. I guess I don't fully understand where it should be connected. The Intellicenter has an ethernet line going to a new high-power wireless antenna (900mhz). Then the other side of that is a High Power Wireless Link...

Wiring pics

Thanks Jim. I have configured every option available. Heater, Intellichlor, Lights. But nothing is controlled.

We had an EasyTouch panel so I got an upgrade kit to an Intellicenter i10p panel. Got everything hooked up. Panel is powered on. Updated the firmware. The system is getting an IP address. But I can't control a single thing. Documentation talks about a service mode, but I don't see a service mode...