Recent content by robbogert

I had previously did this when swapping main boards to test, but I decided to give it one last try. As it turns out, I think is just the generating LED (old style, bulb type) or the contact on the board is faulty. My system seems to be running okay, it is just the generating light does not...

Does anyone know where to order the plastic tabs and mounts for the main PCB and display boards?

Display board is bad. I tried it with my dad's display and it worked fine. I guess it is time for a new one.

Thanks. It had crossed my mind that the display board could be bad. The pins are straight and look fully seated. I'm going to test with my dad's display. I will repost results.

Thanks for responding. Here are the readings while on and generating light lit: Avg. 2900 ppm T. 83 F V. 24.7v Amp. 5.45a %. 80% Inst. -2900 ppm ID. AL-0 Rev. 1.58 Set. T-15 after 2.5 minutes the light started flickering...

I've had an Haywood AquaRite Salt system since 2006. I'm on my 2nd board (v1.58 with thermistor replaced 1x, running a T-15) and 2nd cell (generic 40 Kgal). The replacement cell was installed in 2011, and board is a 2012 (not sure when I replaced the thermistor). Recently the generating light...