Recent content by reddingnative

Hi Jim- I have my pool serviced weekly and the tech will normally set it to time out after adding chemicals or checking equipment. Today I had a new tech and he wasn't aware of the time out issue, so when I returned home it had been running. So we end up texting back and forth. Thanks

I have a Pentair Easytouch Control System installed new in 2019. It's been operating as intended until last year. "Auto" and "Service" Modes operate fine. When "Time-Out" Mode is selected, the Control System is supposed to return "Auto" Mode after 3 hours. In this case, the Control System stays...

Here is the new Select switch. ATI-1203, 12mm, Clicky, Low Profile, Push Button Switch, Short Depth, Domed Top. Depth is 10mm with contact pins. I drilled a clean 7/16" hole with a paddle bit and then used a round file to slightly enlarge the hole so I was able to insert the switch by turning it...

Jim- While looking at the EasyTouch case, I noticed some distortion near the Select switch so I’m assuming something overheated/shorted. So along with that idea I think that caused my other aux buttons to re assign themselves. I’m lucky that my Waterfall function still works which is all I use...

So, working on the switch and install. Thanks. Now, only issue is my aux buttons, Spa, Cleaner, Waterfall, Pool Light. The spa button turns on Waterfall, cleaner button turns on lights, Waterfall button nothing, Pool Light button nothing. This was issue when select button stopped working. The P...

Tom- Just to make sure I didn’t have any other issues, I attached jumper wires to both pins for the Select button. I was able to get to the settings by touching the wires together. I was able to connect to the main control panel. Looks like I’m back in business after I install the switch. I just...

Perfect! And again, thanks so much for the help.

Tom- ok, I was just looking at that link. So one wire goes to where the Select circuit meets the board? And the other wire goes? Thanks-

Tom- How do you peel off the face of the controller?

Tom- I opened the case and everything inside looks fine. I disconnected that ribbon circuit and reconnected it. The Select button still does not function. And I’ve pressed it in various spots. I’m not electronics savvy when it comes to circuitry. If you have any other links related to that...

Tom- I’ll open this up and go from there. Thanks

Tom- You have know idea how much I appreciate your help here. So, no the select button does not do anything. But let me back-up here with some history. The main controller with the wireless easy touch was installed by Guiton's Pools in 2018 after the Carr Fire damaged the original controller...

Thanks Jim, I appreciate your help.