Recent content by Redbridge89

If I understood you right it sounds like there is a leak in your cleaner hose allowing air in.

As water flows through the pipe it constantly loses pressure. If there is a bottle neck in the line the pressure drops more through the bottle neck but does not gain any pressure after passing through the bottle neck. The difference between 2" and 2.5" will be minimal due to short length of...

Thanks! I will slam the pool and quit using tablets. There were times when my pool's chlorine levels were around 0. Thanks again.

As per my tf100 test kit: PH 7.2 FC 5.5 CC 0 TA 130 CH 110 CYA 60 I typically vacuum pool and backwash filter every Saturday but by Wednesday there is green algea starting to form on the bottom of the pool. This started about a month ago. I typically just scrub it and it dissolves in the...

Thanks for your help. I ended up taking water out and putting a concrete block under the front of the buttress. I hope it doesn't settle again. Thanks again.

The post in question is 1/2 inch lower than the rest of the post on this side. It appears the settling is at the pressure plate. Do you think it would be safe filling up and keeping an eye on it? There is only a foot of water in the pool I could drain and re-level. Thanks for your help.

Thanks. It was off the ground so I added wa little weight to hold it down. The buttress is still leaning. I believe the channel has settled from weight of water on tje pressure plate. When I was digging in this area there was a large rock I removed. I must not have done a good job filling...

I have just finished installing my 15' x 30' oval pool. While filling I noticed one of my buttresses is leaning in (toward pool) 1 1/2 inches. I have about 6 inches of water in the pool. The wall is dented in slightly close to this area. Will this correct itself when it fills up and pushes...