Recent content by randelli

You are finished with the shock process when.... 1. Your pool water is sparkling Here is the water from this morning: 2. Your CC's are .5ppm or less I am at 0ppm 3. You can hold your FC overnight without losing more than 1ppm. I lost 1ppm

OK here are the results for the overnight FC test: Sunset: 7:42 Sample: 7:42 FC: 15 CC: 0 TC: 15 Sunrise: 6:03 Sample: 6:03 FC: 14 CC: 0 TC: 14 This should be good right?

I don't think I put any bleach in the pool in a week. No matter, it is obvious to me that my pool is not as clear as the pools chem geek posted, so I am ready to keep on keeping on. I will do the overnight test tonight. I am also concerned about losing 1" of water over the last 5 days. It...

WallyWorld generic bleach. I have used (17) 1.42 gal. containers since April 4.

The camera did add a little cloudyness - I think I moved a little when I took the picture. But, Holy Cuss chem geek, I have not seen water that clear since fishing in the High Sierra lakes above 10,000 feet! You should make a sticky showing what "clear" really means. Here I thought I had...

THANKS TFP FOR ALL OF YOUR HELP :party: My pool water is perfect, the filter does not leak sand, the pump motor has been replaced, the pool sweep has been replaced. Here is how the water looked when I got here on April 4: And here is how it looks today - yes you can read "Hayward Pool Vac...

Probably a dumb question; but my mind thinks up these crazy ideas while I sleep - or when I am in the shower. Follow the logic if you dare. For centuries people have added salt to water to soften it. You can still buy bath salts. I have a water softener at my house that uses salt to...

So Leslie's wants $140 to replace the A frame & turbine kit and the pod kit. I can order the parts online through A1 for $82. I can ebay the parts for $74. I would like to support a forum member with my purchase if at all possible. If someone here would like to take my hard earned money give...

I have a Hayward Ultra that is about 3 years old. The thing won't hardly move, and when it does it either gets stuck on the stairs or hits the waterline and hovers. This is crazy but I am sure it is something simple. My other problem is that I pulled it out of the pool and when I set it down...

Yeah, I had to get a new impeller too :( It is the WFE-3. Pump - $200 Impeller - $84 Where is the logic in that? I replaced the master seal also.

Yes I did get the WFE-3 impeller and also replaced the master seal while I was in there. So 85 GPM would turn over the 19,000 gallons in 3.75 hours. I will set the timer for 4 hours and see what that does for me. I can adjust from there. By the way, my old pump on high for 1.5 hours, and on...

So this week we had 2 good days of wind and rain - and then my pump went out for 2 days. My son (14) cleaned the strainers and I noticed that the pump strainer was in backwards and water was not passing through!!! I think that killed the motor. So today I replaced the motor and tested the...

OK Mark- I replaced the pump with a single speed, HE, 3/4 hp, 3450 RPM motor. I also had to replace the impeller so it was about $320 repair. Luckily I did all the work so there was no labor involved. Here are the readings for the PSI: All Sweep - 5 PSI Middle - 11 PSI Skim & MD - 10 PSI...

Sorry to monopolize the conversation................ I bought a WhisperFlo 3/4 hp 3450 6amp motor that will bolt up to my pump. It will run right in the middle of my old 10amp high speed and 3.5amp low speed.

Please verify proper motor size: Now that I have to get a new motor I should make sure I get the proper size for my set-up. My pool is a 19,000 gallon, in ground, plaster pool. It is surrounded by 8 cypress trees, 2 palm trees, an oleander, and various shrubs so there is always leaves...