Recent content by Pro Golfer Mark

  1. P

    New EVO 614i Robot Pool Cleaner Review

    Just purchased the 614iq and I'm not happy with the dirt pickup on it. It's leaving dirt in the corners of the pool. Anyone else have this issue? Did getting the fine filter fix it? Below are pictures of the pool immediately following a cleaning. I have the regular filter. However, I...
  2. Dirt in Pool1.jpeg

    Dirt in Pool1.jpeg

  3. Dirt in Pool2.jpg

    Dirt in Pool2.jpg

  4. P

    Help Troubleshooting LXi Heater

    I have Jandy LXi heater and I'm having trouble with the temperature sensor. The actual water temperature is 78. The LCD display on the heater shows the water temperature is 104 which is bad because that is the max water temp and the heater shuts off at that point. I disconnected the two water...
  5. P

    Minimum Calcium Needed

    The cost was $525. I'm not sure how much water went to waste. I do know that he hooked up a garden hose from my house to the trailer to replenish water. He also had a hose from his trailer to my sewer clean out to dump the waste. The water in the pool dropped by 1 to 1.5 inches during the...
  6. P

    Minimum Calcium Needed

    Thanks everyone for chiming in and helping out. I had the PuriPool process done on Friday and wanted to report back. It turns out the process didn’t remove all the calcium after all, but did bring it down significantly. First here are the numbers from my TF100 test kit: Before: FC: 6 CH...
  7. P

    Minimum Calcium Needed

    Just some background, I have an 18 month old plaster pool in Las Vegas where we have hard water. I'm getting the PuriPool process done on my pool soon because I'm tired of looking at the stains on my tiles. My CH is currently at 700. Now I'm assuming the puripool process is going to set me...
  8. P

    Is this a normal looking plaster job?

    Can someone take a look at these mid-fill pics on my new pool and tell me if this is normal looking streaking on new white plaster? Particularly the darker streaks on the spa wall by the steps as these streaks have yet to go away after almost a month of daily brushing. The plaster company is...
  9. IMG_1677.JPG

    IMG_1677.JPG

  10. IMG_1683.JPG

    IMG_1683.JPG

  11. P

    Need Advice on Pool Startup

    Thanks for the advice so far guys. I live in Las Vegas. I have since gotten a brush-bottom vacuum as suggested so we are good there. I went to wal-mart and got a bottle of HTH Metal Control and added that just in case. I've been adding a lot of acid and some chlorine. Please see my pool log...
  12. P

    New Pool Build - Henderson, NV

    More pics...
  13. IMG_1681.JPG

    IMG_1681.JPG

  14. IMG_1689.JPG

    IMG_1689.JPG

  15. IMG_1694.JPG

    IMG_1694.JPG