Recent content by peco

  1. P

    Pool Pilot Low Amps reading

    Just an update. I replaced my power module and everything seems to be running fine. I did replace my cell because that happen to be bad at the same time (I tried the old cell with the new power module and got a high volt and low amp reading). I also noticed that my tri-sensor cable has to be...
  2. P

    Pool Pilot Low Amps reading

    I put in a new cell and it's reading 16 volts and 4.2 amps. amps went up and the volts went down :?: In boost mode the volts and amps both dropped a little (15, 4.0). Maybe it's the cable?
  3. P

    Pool Pilot Low Amps reading

    I recalibrate the system for the correct salt reading but again it made no difference. I checked the fuses again and they look fine. It will cost $100. for someone to come look at it....worth it or just buy a new DIG-220?
  4. P

    Pool Pilot Low Amps reading

    Sean, thanks for the reply. I checked the readings again (with the original cell). Volts 28, Amps 2.8 Salt 4800. I then set it to power level 1 and let it run for 30 minutes. Volts 28, Amps 2.8 and Salt 4800. I changed it to Power Level 3 and let it run for 30 minutes again. Volts 28, Amps...
  5. P

    Pool Pilot Low Amps reading

    I'm having a problem with my Pool Pilot Dig-220 (SG-36). I've read a lot on this forum and it's been very helpful. :goodjob: It's reading Low Amps. It's running at Power Level 2 and it reads volts 28, amps 2.1, salt 3000. I ran it in boost mode and the readings stayed the same. I then put...
  6. P

    Which readings to use?

    I just recently had my pool water checked at 2 different pool stores. They are literally across the street from each other and the tests were done within 15 minutes of each other. The problem is the results are vastly different. Pool store one used a BioGuard testing system which appeared to be...
  7. P

    Converted to Salt system

    Thanks for the replies. I took a guess at how much water to drain before I knew about the calculator so I replaced about 1/4 of the water. I added liquid chlorine for the algae, which looks much better already, and I figured I'd wait for this to settle down and test it again. The AutoPilot...
  8. P

    Converted to Salt system

    Hi Everybody. I'm new to this great forum and as a result of reading everything here I have converted to a salt system. I've learned a lot but am now having pools problems. A little history: I purchased the AutoPilot Dig-220 with the SC-36 cell. Installation and set up was a piece of cake...