Recent content by nhr594

I had someone pressure wash the interlock and then added some polymeric sand. Some of it did make it inside the pool. I have vacuumed it all out. I also installed new Hayward heater. By increased water pressure, I mean I am seeing strong(er) flow of water through those two var flow return...

Seeing lot of bubble and foam forming near far vari flow jets. I am also sensing water pressure. Attaching the short link below. Is this normal?

Hi, So few of our edge pavers came off during weekend. What should I do as adhesive to put them back?

How to tell if my pump run time is less. Attaching the results. Pool not looking crystal clear at the moment

Is 8 mil too thin?

Thanks. Can you tell me which one you are using?

Thanks for the reply. Would you be able to tell me to what you are using?

Hi, I am looking into preventing over night heat dissipation. One of the options discussed here is to use pool covers? Does any one have any recommendation on what I should buy? Thanks,

Thanks so I tested my water today, TA=220 PH=7.3 FC=5.5 (coming down) CH=22 CYA=60 Pool Math says TA is outside of the range (60-80). What should I do bring it recommended level?

Sorry not clear on what you mean by 30 ppm of stabilizer. The pool math app shows I need to add 96 oz of dry stabilizer to get to 75. Should I just do that?

Folks, so I think I have passed all slam criteria. What should I do next..turn on my swg and let my FC level drift back to cya/fc chart levels for swg? My cya is 30 and the lecommended is 75 so I should probably add stabilizer to bring it to those level?

So I have noticed that I haven’t been to get my fc level above 10 for couple of days now. I am using liquid chlorine and putting in amount based on pool math app. Wondering what’s going on? Could it be high PH?

Looks much clearly now. Is the quarter test done in deep or shallow?