Recent content by NewToPoolAndThings

Hi Mark, I appreciate the response. I haven't done extensive testing on the new board as far as checking the voltage, and to be honest I'm not 100% sure on how to do it. The only thing I've done was check the ohms of various points. I might send the new board back and grab a new one and see...

After hours upon hours trying to figure this out, I decided to give up on it and send it back. It could of been just a bad board. I replaced the relay and unfortunately it still didn't fix my issue. I posted my current situation here.

First of all, thank you everyone for all the inputs here.  Unfortunately, I've done everything I could find. I replaced the 20 amp fuse and replaced the relay. I actually got a replacement board, but that doesn't seem to be working properly, but with it I know the chlorinator works (I also got...

Thanks, I really appreciate it. Yea, it does seem to be a doozy. I tried doing a config reset to default through the locked configuration menu, that didn't help unfortunately. I'm assuming that's the same as factory reset right? There isn't a button somewhere that I'm missing? I just got...

Hi All, I'm new to this forum and owning a pool. I apologize in advanced if this isn't the correct way of doing this. It's been great, but not without it's hiccups. I recently came across the infamous 'No Cell Power' warning, seen here Aqua Logic PS-4 'Cell Power Error' REPLACE????. I tried...