Recent content by Myko520

Well the pb installed the blower, all the jets were working fine now but the blower will only stay on for 3 minutes and then gets too hot and shuts off. I'm assuming it's the back pressure. The pb initially installed a 1.5hp blower but it was way too much. Now they tried a 1hp and it's still...

He mentioned that he was going to install the check valve as well. The blower will be tied in to the pentair psl4 panel.

Update. My pb is going to foot the bill and install a spa blower on the airline and is convinced this will solve the problem. Question though, I have a 6.5 hp shop vac blowing in the air line and I do have bubbles blowing out of 2 jets but not the other 2. I closed the 2 jets that do have...

I do not. Wish I did. The pb is trying to troubleshoot but I'm certain it has to do with the underground plumbing

Hello everyone, Yes there is a Hartford loop installed and above the water line. I was monitoring the build all the way through, especially the plumbing (I'm a union pipefitter) when the pump is off you can still see water in the airline. Even if you blow it out and return to spa mode if fills...

Yes nozzles were turned on, Airline is a 2" pipe sticking out of the ground about 30' away from spa. And I removed all jets when flushing.

The spa does not have a blower, I dropped the water level below the jets and pushed everything out of the line. The jets that are in place are the HAYWARD SP1434PAKB VARI-FLO JET AIR III NOZZLE

So I just had my pool finished, I have a San Juan desert springs fiberglass pool/spa combo. My problem is.....when you go into spa mode water starts overflowing out if the spa air line. I've lowered the water level below the jets and pushed all the water out but when I fill and start again it...