Recent content by Mustangs19
-
M
New Salt Cell but Easy Touch salt level is 0.
You were right! It’s fixed! Thank you SO much!- Mustangs19
- Post #8
- Forum: Salt Water Chlorine Generators (SWG)
-
M
New Salt Cell but Easy Touch salt level is 0.
This is a replacement for the original one installed at installation of the pool. I just checked and the Intellichlor was switched to off. I changed it to yes. If this is the problem, how long does it usually take to register a new salt reading on the EasyTouch?- Mustangs19
- Post #7
- Forum: Salt Water Chlorine Generators (SWG)
-
M
New Salt Cell but Easy Touch salt level is 0.
They only replaced the salt cell. Do we need to replace the EasyTouch panel, too? Yes, I can adjust the cell’s output from the EasyTouch. Thank you.- Mustangs19
- Post #6
- Forum: Salt Water Chlorine Generators (SWG)
-
M
New Salt Cell but Easy Touch salt level is 0.
Yes. The salt level light says good and the salt cell light is a steady green.- Mustangs19
- Post #4
- Forum: Salt Water Chlorine Generators (SWG)
-
IMG_4515.jpeg
- Mustangs19
- Media item
- Comments: 0
- Category: Pool Equipment
-
M
New Salt Cell but Easy Touch salt level is 0.
We had a new Pentair Salt Cell IC-40 installed two days ago. The Easy Touch Diagnostic is registering 0 ppm. I had the water professionally tested and their reading said the salt level is 3500. Is there something we need to do to reset the panel? Thank you.- Mustangs19
- Thread
- Replies: 7
- Forum: Salt Water Chlorine Generators (SWG)