Recent content by mpcen

Thank you!

I'd rather leave it hanging out in the J box as long as it doesn't introduce any electrical risk. I will move forward this way, thanks a lot everyone!!

My pool was just resurfaced so I’m in the process of starting it back up. The pool surface is pebble and there’s quite a bit of dust. The dust seems to be clogging up the filter causing my pressure to rise to nearly 30. My normal pressure is ~15 I plan on opening up the filter and hosing it...

The bonding wire is running from inside the niche, through conduit, into the J box, but just hanging out in there not connected to anything. It was previously connected to the old 110 light ground and the ground coming from GFCI. The image i attached has everything in detail (before and after)

The equipment (pump, timer, salt water chlorinator) bonded together but are NOT coming into the electrical panel. With that said, should I still run a ground from the niche to the ground on the electrical panel ground bus bar?

Hi all, I replaced my 120v lighting with a Poolexa lighting system. It's a Controller/Transformer combo which is fed 120V from GFCI and outputs 12v to the light. The light is mounted to a metal niche. The light cable runs through the old junction box, through the old conduit, and eventually...