Recent content by Lemoine

Jeff/George Any update on the salt cells. I'm in the market, my ic40 died. Thanks

Here’s another tidbit of probably useless info. When I went out today to clean up the installation I noticed that every two minutes the “PF” error code (along with the service led) would clear for approx. 2sec and show the water temp then right back to “PF”. I watched this for about 10 minutes...

James - The heater is actually in great shape internally. No corrosion, you can tell it was hardly used. I’m one of those guys that love buying used stuff when it looks like a deal. I got this heater for $150 so I figured I couldn’t go wrong. The seller stopped using it when the keypad...

Of course. It's the expense one!! Thanks for your time James. You know of anyone who repairs those boards?

Absolutely. Sorry for the confusion. I also tested voltage to that ground - - - Updated - - - Not sure of the exact year. I'll check tomorrow. I can tell you it's between 08-10. It has 4 fuses on the wiring board.

I grounded both grounding lugs on each side of the heater just to make sure and checked voltage with respect to this ground and it all looked good. I was leaning toward the ICB but wanted a second opinion. Thanks

I bought a used H250 that had a sun damaged keypad. I replaced it with an aftermarket keypad from INSYNC ENGINEERING off of eBay. After plumbing the heater and applying power (220 V) I get a constant error code “PF”. The blower also runs continuously. I’ve taken readings and I’m getting correct...