Recent content by lc7118

I've had my master temp 400 since 2017 and it seems like I'm replacing sensors and part on it annually. Currently its turns on, heats for about a minute, then shuts off for a minute, then starts on again, and repeats this endlessly. Its showing a HLS error, so I replaced the HLS and ACG...

So its looking like I do need to do a SLAM. start: 5 end: 3.8 I will start to research that now... Thanks all for the guidance!

alright, so the results of another ONCT start: 4.2 end: 3.4 combined chlorine: .2 I mornonically forgot to turn of my UV light system which I know breaks down the chlorine, So with a loss of only .8 FC, am I correct to assume that I passed the test and the culprit really is the SWG?

thx for the info in the manual: its at 10k+ hours

Its about 5 years old. Mine doesn't have a control panel so I don't believe that I can check the hours.

Thanks for your response. I attempted to do an OCLT last night using my k-2006. I did add a lot more chlorine than I needed. I must have put something in wrong in Pool Math. start: 9.2 end: 8 However, I don't think I was aggressively swishing the solution enough last night. The pink was...

My IC40 salt cell has the high salt light flashing. I have tested multiple times with the Taylor kit and it shows my salinity reading at 3400ppm, so I'm confident that the actual levels are good. The cell is about 5 years old. Pool temp is high 80s I cleaned the cell a few days ago. The...