Recent content by lambed3

This fixed it. Thank you.

I wasn't given any 🤦😂

Since you guys got me sorted on my last question (thank you!), I'm back here with another one. I have a pool and spa. The pool company put two lights in the pool and programmed them with Hayward omnilogic. Since this is an ongoing project, I asked them after the fact to add a light to the spa as...

I'm all set. I removed and added back to the controller and now I'm working. Thank you for the help!!

Got it to register but now it only turns on the fan blade l for 10 seconds and then stops. I think it may be the wire but I'm not positive. Using 18 gauge thermostat wire that I picked up from home Depot so that I have 3 wires instead of 2 wires. Any ideas?

Which is the Omni COM Bus in the panel? Assume the one with wires in it vs the one labeled HS Bus with no wires? When I try to add the heater to the controller, I only see low voltage and high voltage relays as options. Do I need to select it differently now?

Thank you - let me try that. I was trying to use the wire that the pool company left me! They only provided a 2 wire.

I have a new pool that is mostly up and running from an automation perspective but the pool company ran out of time the last time they were here and didn't finish wiring/connecting the heaters. I have a pool and spa heat pump but the one I care most about is the spa one as that gets daily use...