Recent content by kdzv

thanks i will try it out today... does anyone know what the volt/amp reading should be in power level 2?

Well we ordered a new cell, worked fine for a month today we started getting the 'warning check/clean cell' again 19v 4.5 amps water tested on tuesday fc & tc 1 salt 2900 calcium 230 cyanuric 40 total alk 100 ph 7.8 copper & iron 0 phos 200 temp 80 i dont know where to go next, cant afford...

we went ahead and ordered new cell. is there anything special we need to do to install it? thanks for everything.

anyone have an opinion wether this is cell failure or cord failure...

The blades appear to be okay. My water test last night showed: free chlorine 1 total chlorine 1 salt 3500 calcium hardness 200 cyanuric acid 0 total alkalinity 70 ph 7.8 coper 0 iron 0 phosphates 900 (i ran the test up yesterday morning also, and this was a 50, so not sure if this is an...

Thanks. The cell looks fine. The read out is 24V/3.5 AMPS, I can get it to 6.5 AMps by disconnecting/reconnecting the cell cord (it stays for 2-3 hours then drops to lower amp reading). I have: 0 free & total chlorine cyanuric acid is low (0) total alkalinity is low (70). We will be putting...

i believe the tri-connector (i referred to) is actually the cell cord, it has three female which connect to 2 males at the cell and a red and black plug which connect to the box...

We have an autopilot sc-36, almost 3 years old. Past couple days we have been getting the check/clean cell warning. Cell has been cleaned, looks great...salt is at 3200ppm...3.2 amps. If we take off the tri-connector at the cell and reconnect the error goes away for a couple hours then comes...