Recent content by jsdrexel

Not a lot but some -- not sure why it's cranking out so little chlorine? Is there some voltages or something I can test to make sure the system is running effectively?

I cranked up the system to run BOOST and it actually made some chlorine --

Hello, we have a Nature2 Fusion Soft 1400 cell that we recently replaced since the old one didn't seem to be making any chlorine - the new one we just purchased also doesn't seem to be making chlorine either? Our salinity level on the panel is running around 3.2 - 3.4. I was told 3.5 is as high...

Having the same problem again? I totally pulled the power from the entire system, but everything fires back up and the pump is running in it's scheduled mode, but any button I push on the Zodiak does nothing? Can't change speeds -- no menu option -- nothing? We had a power outage, and before...

I have not tried that, but I rebooted the system and it still did the same thing. I was able to use the menu when the system is in the stopped mode after the timer turned off the motor, but it seems while the system is running in the timer mode, I cannot do anything? Would that be the case...

Hey all, I have a Jandy E-Pump with Zodiak controller. I'm not super familiar with the interface, but right now it's in it's timer mode where it runs from 8-5, and I cannot do anything on the controller? Is there any way around this? How can I stop it or get to the menu to make some changes...