Recent content by jpage4500

Hi, I know there's other threads about this topic but they seem pretty old and I was wondering specifically about a couple questions that were asked which I didn't see an answer to. #1 is this post and the question was "While i look to replace that Fuselink as a first stop, can I also bypass...

It's back!! I replaced the 2 amp fuse with a cheap one from an AutoZone and voila - back to where I was originally (turning on and off)! That's a huge relief since I thought I had cost myself big time. I also took a video this time of the heater turning on and off and just happened to notice an...

Would that be caused by something like a gas line pressure issue? That's probably not something I can figure out myself.. but wondering if there was something I could test before calling in help. I did see this chart in the service manual.. not sure I'm able to test many of these things though

It's natural gas. I had turned it on earlier and noticed the temperature sensor wasn't working and had just replaced it. I had replaced that temp sensor a year or so ago previously as well. That one was pretty easy to spot as the spa temp was listed a lot higher than the actual temp and the...

Thanks for that manual link!! It's a lot more detailed than anything else I've seen to-date

I'm praying that's the case as I'm really mad at myself for possibly making a semi-easy repair MUCH harder. I was already trying to figure out if I should take a stab at buying a new control board ($400+) just to 'see' if that gets the display back on. It's very difficult to get a pool tech out...

When I turned my pool heater (Jandy Jxi) on this year it turned on for maybe 10 seconds and then turned off and would repeat this over and over. There wasn't any error messages displayed. I searched and made a list of a couple of things it could be and figured I'd try testing them 1 by 1.. -...