Recent content by johnrogers59

that's pretty much what I was describing....I don't think I will worry about it. thanks again

So Dave Please don't laugh too hard when I run this by you... My old pump was rated at 50 gpm, and my new one is 70 gpm... I am planning on upgrading to a larger filter but it may be a month or so to get it...so I was thinking that flow rate was related to pressure...and if I reduced the...

I just checked the drain plug on the back of my new pump...it was loose....put some Teflon tape on it and tightened it back up........NO MORE BUBBLES !!! thanks for the advice....Word to the wise for everyone "check all fittings and plugs even on new equipment..."NEVER ASSUME"...

Got it....checking on a new 24" filter...so before, when I had the 3/4 HP pump and ran it 24/7 I was probably just getting by. How long would you recommend I run my new pump with a 24" filter ?

what problems can I expect to have until I get a new filter? I have had this filter for 8 years. I have not noticed any previous filtration issues.

thanks Jason I purchased this new pump at a very reduced sales price... It is a 1 1/2 HP pump...my old pump was a 3/4 HP....is it possible I have caused or will cause future issues with my system. My 18 inch Pentair filter is rated at 38 GPM max...(just wondering)

Thanks for the advice....I will look at the o-ring and drain fittings....this a brand new pump and motor and I failed to look at the o-ring and drain fitting....I assumed they were fine... but maybe they are not ....also I will try the shaving cream trick...I have asked this question before but...

I am seeing air in the pump strainer basket...

Thanks for the clarification Dave....

So I am troubleshooting a suction side leak. Is it a fair assumption that if a hose fitting and clamp are not leaking water...(I can't find any drips at any fittings) that air is not getting sucked in also. In other words can air get sucked in with no loss of water? I know this sounds like a...

Hanging it in front of the pool return was going to be my next question....thank you for the prompt replies.

For years when adding CYA to the pool I have always added it to the skimmer. Usually in 5 pound bags. It always stayed in the skimmer for a while and then dissolved. I was always told not to back wash for at least a week. While reading some of the posts on this site I read a neat trick of...

thank you, I have some initial questions, should I post them here or start a new post for each?

I am happy I found this site. I have owned a home pool for 25 years and I look forward to learning from everyone.