Recent content by JohnR1602

  1. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    I'll give the warranty a shot since I just replaced the board and it looks clean on the back. Thanks guys, I appreciate the help!
  2. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    Platinum Edition Replacement Salt Cell for Hayward T-CELL-15 purchased in March 2019
  3. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    Compupool Cell, never had any issues with it. I just cleaned it yesterday to see if that was causing any issues. The numbers were the same before I cleaned it.
  4. image0.jpeg

    image0.jpeg

    • JohnR1602
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  5. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    It's a Compupool cell so I can see the water running thru it. I'll check the flow switch
  6. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    Here are the pics of the board
  7. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    Pic when I started the system. After I hit the + button, the Volts went from 29.78 to 29.76 and the Amps went from .07 to .11. Water sensor says 138 degrees. Main software 2.93, Display software 3.00 5L0411-1006015 It's an old system. I replaced the GLX-PCB-MAIN in June 2020
  8. J

    AQL-PS-4 Amp +.07 Salt 0000 PPM

    Salt level is currently tested at 3700. Screen has following readings - +29.78 V +.07 A 96 degrees (AZ Pool) 0000 PPM salt reading. Any idea where I start, it didn't look like there was any issue with the K1 solder point.
See more
Top Bottom
Back