Recent content by jmarsh56

I replace the indoor board and everything seems to be working fine. I am assuming the old board was going bad which is why sometimes it was communicating and other times it wasnt. I will update this if the new board shows the same problems over time.

Thanks, I am thinking the indoor control panel board is going bad. I believe this as sometimes it works fine and others it doesnt. I plan to replace the indoor board with another one I have and see if the problem goes away.

The wireless control board outside is a Jandy PCB E02525-ASSY E02538. The RS Control Panel inside is PCB 7750D Assy 7751. Not sure this helps.

So I went out and took off the cover of the wireless controller out by the pump. There is a red and green light. The red light is flashing. If I press the reset button I can see everything back on the panel again but when I press the buttons on the panel I get nothing. I took the cover off...

when I am getting that error code I cant do anything on the screen. I will check the Menu/Help to see if there is anything there that is doing it.

On my Jandy panel I am getting the following error code: MODEL 8156 RS-8 Combo REV MMM I got it originally last night. I turned off all power to the system then turned it back on. The panel came back up normal. I woke up this morning and it is showing it again. I have tried searching...

Wanted to send out an update. I replaced the switch membrane and now everything works. I am able to make adjustments to both the pool and spa temperatures at the heater. Thanks for the help and hopefully this will help somebody else in the future.

Yes it is connected. It is peeling apart for sure. I am going to agree this could be the issue.

I would say two wire. I looked at the three wire diagram on page 30. the three lines labeled spa line, common line and pool line are not connected. the jumper is configured as the top one (External control interface circuit disabled, heater membrane pad enabled)

I went out and did what you said. When I first turned on the heater it was in pool mode. I tried to press the button for spa but nothing happened. I then went to the panel outside where I put it in service mode and put it in spa mode. The light stayed on under pool. I tried to press spa but...

will do today and I will let you know what happens. Thanks

That is the question I have. How do I set the temperature on the heater? I read online that you press the yellow button on the back of the board and the system would turn on. But when I press the yellow button I get nothing. I cant see anything when I do that.

Sorry I have it set to 102 plus I upped it to 104 with the same results.

I just bought a house which has an ingournd pool/spa combo. I have the Jandy Aqualink RS control and pump plus two heaters (STA-RITE Max-E-Therm 400 model SR400n gas heater and AquaHeat LS Model MBP-150A Heat pump). If I want to heat the pool quickly I use the gas heater, if I want to maintain...