Recent content by JimATX

I've tried various options to reset (power disconnected) and no luck. Removed the control panel and the Display connector seems to "fried" (see attached pic). How do I get into the lower housing to replace this connector/ribbon? JimATX

After cleaning the panels again I found 2 with holes in them. 1 reg and the half panel. Any opinions on replacing all with Hayward, replacing jus the 2 with Hayward, or replacing all with off generic brand? Full set of generic is 1/3 the cost. Also, if I replace just the 2, any issue with...

Pump is running fine... water movement is not strong and the cleaner (Polaris) is not moving well. I replaced the cleaner in the fall and it is in top condition. I sprayed off the filter grid panels but the water flow is still low and it is not cleaning. Also, since the panel cleaning the panels...