Recent content by Jer34

Local pool store recommended the A+B, just finished applying it. Doesn’t look too bad? Supposed to take 1 hour to cure so we will see how it holds up. Appreciate all the help :)

Thank you! I was thinking the best repair would be to replace, but am a bit concerned about the cost and amount of work involved. Will try the epoxy first to see if that holds.

Just opened my pool a couple of days ago for our 3rd season, and noticed the water level was lower than the previous 2 years. After a couple of days of it being open this year, I’ve been noticed the water level dropping approx 1” each morning. I then noticed a fairly large crack in the bottom of...

No weir door, and I always keep the water level around the middle of the skimmer opening, there’s a little dash to show where it should be

Hi, wondering if anyone has any tips or products for clearing up the top of my water? Pool chemistry is good, and there isn’t any algae, but in the sun light I constantly see very small bits of either dust, dirt, pollen, etc There are lots of plants/gardens/trees around the pool and...

I had forgotten to reply sorry!! It ended up being the pressure switch inside the heater which was dripping after I had tightened the SWG with the oil filter wrench. Took the heater apart and tightened everything, it’s all working now. Appreciate it

Thank you, appreciate the help. I just opened up the entire unit and I’m not sure if the drip is coming from the pressure switch. I tighten the end on the side and turned the pump on, no drip from the switch. But can see the water running out near the bottom, can’t tell where it’s coming from though

Just got both wires off, but when I try to tighten the WPS it just keeps spinning and spinning, doesn’t tighten. Picture below of drip under the heater

It’s a Hayward H250ED2C. I was only able to disconnect one of the wires, can’t seem to get the other one off. And when I try to tighten it, it just keeps turning and twisting the other wire