You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
G
Finally got around to testing the salt level and I came up with 3100 ppm. So if the instant is 2800 / actual of 3100 that works out to...
-
G
Note that if you make the temp read 60 F, or lower, the production is limited to 20% even if the percentage shows higher.
-
G
I did manage to scrounge up a 10k pot. If the cell seems like its going to continue to work I will use that 10k pot and a additional...
-
G
Looks like the salt level drifted up some overnight. I expected it to as I had added a bag of salt and balanced the PH and Chlorine...
-
G
I can get that info in the morning. How do you get the instant salinity?
-
G
Lots of rain today. So I had to clean the leaves out and balance the water. I went ahead and added a bag of salt figuring it was low...
-
-
G
It may be on its way out. That’s why I want to “solve” the hot problem enough to test it. But I also need to verify that there is enough...
-
G
Was able to get some at work today. Tonight I will temporarily clip them to the ends of the wires and see what happens (weather...
-
G
Going to start with a resistor first to see if it makes a difference. No sense spending a bunch of time if the cell is worn out.
-
G
I clipped one of the wires and turned everything back on. It started like normal and worked for about a minute then the “inspect cell”...
-
G
It does default to 77 with the cell unplugged. I removed the cover on the cell to expose the wires last night. Looked thru my stash of...
-
G
Quick question regarding the T-cell thermistor problem. Can I cut either the red or blue wire under the cover of the cell to "trick" it...
-
-
G
Slightly different board but still the J4 jumper.
-
Loading…
-
Loading…
-
Loading…
