Recent content by greentoblue

Ok I think you have it figured out - it’s about 35 feet long from the meter to this pic and there is no regulator currently near the heater- perhaps with a regulator adjusted properly one of these three will work or a new one with work and reignite a 2nd time

This meter was left behind after a 3/4 line was installed 3 yrs ago to cover the larger gas pull. It seems I may need a bigger meter as well. All of the electric seems fine but the two replacement valves only work a single time then just make a clicking sound as it tried to reopen a second...

Ok I will call the city and request a replacement meter that is also larger. After that I will work to clear out any sentiment. Does the 12 psi on that meter seem right, is a manometer measurement different? Could it be sediment ruining the gas valve after the first run and would that mean I...

The meter was left behind after the gas line extension for the heater. We have a central gas heater, stove and tankless water heater all pulling from that meter.

It looks like the meter reads 12 psi and it doesn’t move as the gas valve tries to open. I am almost certain if I install a new gas valve it will work the first time but not a second.

Here is the heater itself with a meter attached - and a pic of the meter

TY for your help! The blower runs as it tries to kick on, makes a clicking sound at the valve. I replace the valve a second time and it ignites and works properly only once. I believe it is connected to automation, service heater light, I can recheck the diagnostic leds but believe we have...

Ok so I have a Mastertemp 400 just out of warranty the won’t reignite. At first it wouldn’t ignite at all and after a rundown of all the possibilities with my pool guy it came down to the gas control valve. I bought a used one on eBay and it ignited but wouldn’t reignite. Thinking I shouldn’t...