Recent content by goldmaes

I think my concern is where you are going with this. My ScreenLogic is wireless and I believe it would only work (or fail) sporadically and not reliably have the same problems. I also should have stated that I am on my second pump with this problem (the 1st one died) and my second salt cell...

Yes I did and it worked fine. It never seems to be a problem with the lights as they always work fine on ScreenLogic. It is only the pool/spa mode and heater on/off that doesn’t work well from ScreenLogic.

Yes, things work fine from the Easytouch controls with respect to the valves, spa, and heat. For one reason or another it doesn’t matter what I set the Easytouch on for lighting it will always start with the “sunset” lighting routine. As far as ScreenLogic, some features always work fine, the...

My Easytouch system is about 10 years old. If I just leave everything alone it works just fine without problems, however I have had some annoying issues that I am not sure if they are solveable. It seems to have a mind of its own. If I turn the spa on and then put it back to pool mode from...

Thank you guys so much. I got everything and then realized that the spade connector from the transformer is smaller than what fits on the 12A breaker. Back to the store to get another connector! UGH!!!

Thanks so I much. I have a proper stripper. I love this website, everyone is so incredibly helpful.

Thanks! Is any special crimping tool needed with the WAGO or just push the lever down?

Ok, that I can do, last question though you mentioned 22 gauge wire and the red wires say they are 14AWG 600V 105 degree C. Shouldn’t it be 14 gauge wire? Not questioning, just wanting to make sure. Thanks.

That I can do, however I hate saying this but I am not an electrician so I wasn’t sure of the following: Is there a certain, type, gauge, etc of wire I should use? Additionally is there a certain type of female disconnects that I would need to have so it properly connects to the circuit board...

As I had previously written, I have an Easytouch system that had intellichlor installed a couple of years later. I didn’t want a separate power center installed on the side of my house so the installer did so with the transformer, etc in the automation system. Later I realized that while it...

Thanks so much. I really appreciate all of your help.

Thank you. Yes both solutions would work and with the additional RS-485 connections it would most likely be cleaner. If I did do that I guess you would just take one of the red connections from the transformer directly to the card and the other to the fuse and the cable that is attached to the...

I need one because I currently don’t have one. When my SWG was installed I recently realized they just took a surge card from the separate box and left it hanging in the high power side of my automation system with no attachement of the heat sink to the back of the system. Not sure if it is...

I need to get a new 521218 surge card for my Easytouch system. Pentair charges a fortune and I see many other that are way cheaper. Does anyone have any experience with them? Are they as good, problematic? Any thoughts would be greatly appreciated. Thanks.

Thanks. Next time I may give that a shot. I appreciate it!