Recent content by gardenfreek

When we hit boost it reads 0 volts 0.2 amps.

OK...so we received the replacement cord today, and no dice. It did not solve our problem. Any ideas? We have a new Cell and new Cell cord, but we are still getting low amps readings. When we check the amps they range from 0 to well below the normal. Any help would be appreciated:)

I am awaiting the arrival of the new cable. I'll keep you posted.

Thank you so much for the advice. It worked!!:) We ran a jumper wire to bypass the pressure switch and the heater fired up. Thanks again for the advice. We will order a new pressure switch and be as good as new.

Thank you for your help. We tested the cell cord with an amp meter and there is no current running though the cell cord. The display on the autopilot says 0 volt and 0 amps.

Thank you for your advice...We did adjust our chemical levels. Here's where they are...pH is at 7.6, total alkalinity is at 80ppm, CYA is at 35, and salt is at 3100. We also put in Phosfree to reduce the Phosphae levels int he pool. Still nothing. We disconnected the cell cord to check to...

A few weeks ago we turned on our spa and heard a loud pop noise. We inspected the heater to find that the blower had "blown up." We replaced the blower but the heater will not ignite. We reset the system by turning off the power...still nothing. The display shows the SW Pressure and...

We just replaced our Autopilot SC-60 cell with an aftermarket cell, Compupool GRC-AP60. It has a 2 prong cord instead of 3 prong. We read that it should work fine, but we have been running the new cell for 3 days and no chlorine production :hammer: We checked salt levels and added water...