Recent content by Frank Cowart

Thanks for all of your help. I wish we had a technician in this area with your expertise. Attached is a troubleshooting guide that I found, after a lot of searching, that might come in handy for you when helping people with Jandy heater problems. I'm going to do as you suggested and check the...

Thank you, I will do this. The only difference in the way I'm wiring it is that the flame sensor is wired to IGN/FS and the ignitor is wired to IGN/240 and off of the terminal block for the transformer. Also, thank you for your service. I graduated from high school in 69 but thank God I didn't...

Thank you very much. I was very careful not to touch the igniter coil when installing it. Do you think I could put a fuse between the LI terminal and the ignitor. At $150 a pop, it gets expensive. Thanks again, Frank

Thanks for the information. I have the manual and the heater troubleshooting guide and I have a multimeter. Some more information: I had to replace the ignition system and the ignitor because they were actually destroyed, not because of the diagnostic error. I've had a lot of problems with...

I have a Sunpool Ocho Rios Swim Spa pool with a Jandy model zodiac lrz Electronic Heater Model Number: LRZ400ENN and Speck pumps. I am constantly having a problem with the heater and there isn't any knowledgeable service in this area, so I'm hoping someone here can help me out.

I have a Jandy model zodiac lrz Electronic Heater Model Number: LRZ400ENN that was giving the message "FAULTCHECK IGN CONTROL". The Fenwal automatic ignition system was bad and so was the Hot Surface Igniter. I replaced both and the heater worked for about 1 hr, before the igniter burned up...