Recent content by fklarrison

Have you tried Dave's Pool in Greenfield

Try Dave's Pool in greenfield. They are one of the best in indiana. The only thing is I don't know if they go that far.

I need to clean my pool pilot digital cell and the manual says to use a 1 1/2" cleanout plug. That is way to small to fit. Does anybody know what size fits it.

I'am using the TF-100 test kit. My ph was 7.5-7.8 before shocking.

Liquid 10% chlorine. Fc=23 Cc=0 Cya=90 Ph=7.0-7.2 Ta=110 Ch=230 Salt=3100

I'am shocking my pool to clear up cloudiness and I notice when I shock that my ph drops to about 7. I thought that it was suppose to rise when you have high chlorine levels

Just to add, I have the pump relay also. You do not have to use it if you don't want to. It shows you in the instructions how to wire it both ways. The relay is used so you can turn off and on pump with the program.

I have a pool pilot digital and if I turn off the pump with the old switch I have to manually turn pump back on with the Dig 220 after I turn on old switch. If the power goes off I have to turn on pump at the Dig 220 also.

I have a pool pilot dig with a rc42 cell & 32300 gals of water. I'm trying to get the per cent purification set. It is on power setting 1 and I have it set at 65% and it still is not keeping up. When do you know when to switch to the next higher power setting. Fc=4 Cc=0 Ph=7.5 Ta=110 Cya=90

I put the chlorine feeder back in line as a backup. Three weeks (installed end of may ) after I installed my autopilot the tri-sensor flow sensor broke and I just recieved the new one yesterday. Up and running again. Part was on back order because of factory damage in Japan. Dont know why it...

I have a hayward cl220 chlorine feeder and I need a new oring. I checked online and the prices are from $5 to $30. Anybody have any experience with purchasing one of these orings.

Thanks for the quick answer. Really enjoy reading and learning from this site.

What is clarifier. I thought I read it here once, but can't find it.

I have a Infinity 4000 pool cover that sometimes does not want to close. There is a magnetic pickup on the end where the cover pit is that stops the cover when it is fully open. Does anyone know the setting or gap amount to adjust this switch to. I think the cover may be opening to far and when...

Thanks Sean, i will post my numbers. I did add muratic acid to lower my ta. It was 150 and I got it down to 130. That lowered my ph from 7.5 to 7.2. The poolpilot was installed at this time but not running. I do have a Hayward automatic chlorine feeder installed in line after the poolpilot that...