Recent content by er23423

ebrow That's the information I was looking for, Thanks! There are no breakers inside the Hayward unit.

Thanks for the reply Jason. Inside the PS4 it lookslike there are 4 relays. Are those what need to be GFCI? The relays: http://www.mouser.com/ProductDetail/Omron-Electronics/G7L-2A-BUBJ-CB-IN-DC24/

I two 220v electric wires running from the main panel to two 20A switches next to my outdoor equiptment. Then from the switches to a Hayward Aqualogic PS4 automation. One wire appears to feed the pump and the other feeds the panel. A house inspector says this all needs to be GFCI. What's the...

Has anyone thought of using a Powerline Ethernet adapter and just eliminating wifi? Amazon.com: TP-LINK TL-PA4010KIT AV500 Nano Powerline Adapter Starter Kit, up to 500Mbps: Computers Accessories This unit would need to plug in near the aqualink and you would have to protect it from the...

UPDATE: I powered the pump and programmed the realy to run 24hrs. (well max allowed, 23.5hrs) Everything is running smoothly. Thanks for all the help!

UPDATE: I hacked off the old half of the union and put a coupler over the 2" pipe. I let it cure overnight and it's held well for the past two days. I appreciate all the help and advice!

Update: No luck finding a match. If I hack off the old Union. Is the 3/4 inch bare pipe coming out of the multi-valve enough surface space to get a good seal with a coupler?

I tried both Lowes and Home Depot. Both were mismatched. I am going to try Leslie's today. I found the Hydroair brand(now Balboa) online, but shipping is a week. https://www.amazon.com/gp/aw/d/B00309YX56/ref=ox_sc_act_image_1?ie=UTF8&psc=1&smid=A401NOVPDA3ZS

I am stuck trying to replace my pump. I unscrewed a union and need to replace the female side of it. The male side had no room to be saved. A new 2" union I bought does not match the threading. The existing union manufacture is HydroAir. What are my options? Should I cut it off? is .75"...

There are 2 lines coming IN; but 4 going out. 2 go to the pump and the other 2 are going to the heater. Thanks for all the help!

Thanks for your reply. I believe my busted single speed is running through the relay. It goes two lines in > Relay > two lines out to pump. The relay is run by the automation timer on the Aqua Logic. So do I just program the Aqua Logic to leave the relay on 24x7?

Hayward Aqua Logic AQL-P-4 (10yrs old) https://www.hayward-pool.com/pdf/manuals/AquaLogicAQL-P-4InstallationManual.pdf Hayward Tristar SP3200VSP Current setup is two 220 volt loads coming into the Aqua Logic. One main pump and one waterfall pump. My main single-speed pump went out and being...

Same issue as well. Automation systems make a click when the relay actuates, but no noise or action at the pump. I tried swapping out the capacitor, but nothing changed. I opened up the Hayward Aqua Logic system, nothing looks blown out. Update: I tested w/ the multimeter, this was a big...