Recent content by dorn4ever

Thanks. Going to try and clean the pilot orifice and all the connections to see if that helps.

This may be an easy question for someone that's had the issue before. I have an older Hayward H150 millivolt natural gas heater that will not fire up. The pilot is lit and looks like a good flame. I'm getting about 390 mv throughout the safeties and back to the gas valve. Is 390 sufficient to...

Did you ever get your heater working? If so what was the culprit?

Yes I forgot to mention it is an overlap and that is the type I need but.... So as Mdragger88 said in their reply if the bottom is in fact circle/pool "shaped" then where the cove (where the liner starts to come up the wall) is supposed to be is actually going to be a foot and a half up the wall...

Hello all, I have a brand new liner that was given to me by a friend that took their pool down. My pool is 21 feet round and I just learned that the liner is actually for a 24 foot round. I have never changed or dealt with liners (yet) so I am just wondering if anyone knows for a fact that I...

Thanks. It is 22 inches diameter and 69 inches circumference and that looks to be the one I have.

I'm trying to figure out what brand/model filter I have so I know how much media to put in because it needs to be changed. I got it used and there's no label. Does this take 2 bags or 3 and what type should I go with silica or zeo or what. Can it use any kind?

Hello everyone, I recently bought an older Hayward H150 millivolt heater in really good condition the only thing is that the previous owner has I think one of the limiter switches jumped out. This switch is way at the bottom by itself. The manual only shows 2 limiter switches (1 manual, 1...

Thank you for the reply! I'm following a flow chart but I'm not sure if these tests should be performed with everything on like I'm trying to fire it up, gas valve on, switch on, water flowing through? I have the water going through but switch and gas off. On the flow chart I got to the black...

Thanks for replies and sorry for the late response I was expecting emails when my thread got replies. Anyway, to simplify explaining my original post all I did was use the "body" including the manifold, header, burner tray etc. And a couple sensors. Basically all of that was so far deteriorated...

Hi everyone great site lots of info! So here it goes.... I have an old lasts lite heater with electronic ignition and natural gas house has natural gas. The heat exchanger and most things are rotted out. I got a old but ten years newer in way better condition laars lite 2 for real cheap it's...

ok yeah there is a valve on top of the header. i remember water coming out of it when it would run long enough because i thought there was a leak somewhere until i noticed where it was actually coming from. also i can pull up on the lever and water will come out. so does that mean it's working?

thanks for the reply. ok i will try and test the safeties and see what i come up with. do i turn the unit on and test for 24vac starting with the transformer? and as far as the bypass valve goes are you talking about the one that diverts water to the heater or is there one on the heater itself...