Recent content by digger01

Re: CSPC36, Shld I buy new cell - Controller wire is melted Hi All, I have an email into compupool at this time.. I am a little worried about spending monies on a new cell only but it seems like the cell has its own warranty. Would I void it if I hook it up? Seems awful expensive for the...

Hi All, We have obtained a used CSPC36 with a burnt cell. Is it worth buying a new cell at about $400 for this? does the cell come with a warranty or guarantee? The original owner experienced a short in the end with the elec connection. The controller seems fine but the wire is melted on...

WE just slice the bag and let it sit on the steps. It is gone by the next day. We have a vinyl pool.

I need a little advice. Last week I hooked up the new pentair superflo and upon powering up it blew fuses and more. Wiring example supplied verbally by Pentair was wrong and the diagram was blury - so I did the wiring. Now the pump doesn't work so I feel the motor is blown. Also, I don't...

I called Pentair service Monday eve. and we went thru a couple of tests. My pump is not changing speed, it should operate on high and then I switch it to low. Pentair put a service call in for me and said a service representative will call within 2 days and then come to check it out. One...

Thats what I am hoping for. I will call Pentair... I will get new toggle, maybe they will supply one that operates with a definitive up down toggle feel. Its ..a nice rubber toggle but doesnt seem to have a good feel or switch

Thats it! That is the way I have it. But no change in motor speed when I toggle? Can the toggle be defective or burnt Its running strong right now until?? I feel on low. you can't hear it until are about 15' away. So very quiet. The side jets feel strong but I cant see the floor jets...

ummm you can read that diagram. It is blury on the pump!! I need glasses. So do I need another leg to #2 on pump? maybe by a pigtail? or just move the red wire to #2?

It worked!!! I moved one red supply wire to the #1 position on pump. The pump is running. But it is slow but when I toggle the switch on the back of the pump it doenst change any speeds. Just on slow. Did I blow the switch? My wireing is such that Switch #1 position with a white wire goes...

So I should move a red from position 3 to 1. But it looks as if this is not connected to anything? The pentair guy stated to connect a red to the white and black. I thought putting the wire on position 3 ocnnected it to the white and I did a direct connection with the black. I will switch...

Well here are some pics. I turned elec on and the breakers clicked off again... I disconnected the red wires and they do measure 110v. The pump came with a white and yellow (connected to motor) and a black (pigtailed w/plastic cap). I removed the black wire and connected the red to directly...

thank you for those kind word. I agree this isnt good for me and everyone to decifer my english. I will take a couple of pics.