Recent content by Ddave23

We had a local Pentair reseller come and look at our heater, the compressor was replaced per warranty and we have had no issues since.

In case anyone comes across this post in the future....the stain was not algae. We had metal (not sure if it was iron or copper, etc?) staining in our pool. Stains came right with metals treatment. Now, will start to rebalance water. Thoughts on continuing with Sustain Pool Chemical system?

Thank you for the reply. We are not sure if it is indeed algae? It almost look like a stain? Is there any way to determine if indeed it is algae?

We opened our pool for the season last week (inground 15k gallon vinyl liner 9 years old) and when it started to clear up, we see what looks like black algae. Talked with the pool company (showed them a picture) and they told us to put 6lbs of "Burnout 73" and 14oz of "Banish", wait 24 hours...

We inspected all wires and did not find any they may have been chewed or burnt. I have attached pictures of my setup. These pictures are of the control panel wiring and the main wiring.

Hi all, We opened our pool a few weeks ago and started the Pool Heater (Pentair UltraTemp 120, 7 years old). The pool heater ran for about an hour or so, then tripped the main Pool breaker in the basement. We reset the breaker at the panel and the breaker at the Pool Heater location. The unit...

Hi All, I am new pool owner and member of the forum. We have an inground 15x28 vinyl liner pool. We would like to add the SR Smith Typhoon slide to our pool. We would have to "stub up" through the concrete deck to install plumbing for water slide. It doesent look to be to bad, as we only need to...