Recent content by dave300

  1. D

    Pentair flow valve part 471424 Or approved equal help

    This one is also shown as OOS, Icannot remember but I think I came across this site in my search? Thank you for the attempt sir. Dave
  2. D

    Pentair flow valve part 471424 Or approved equal help

    Helping a friend who is in search of this item or any potential equal. Im not sure of the backround but an extensive search has not yielded any luck in locating this item. Thank you all in advance. Dave
  3. D

    Help/Suggestions for deck drain material.

    Do you recall where it is you purchased yours? Do you mind posting a picture? Thanks again sir!
  4. D

    Help/Suggestions for deck drain material.

    @mknauss Here you go. Thanks for any input. They actually will even stand up further out of the deck with higher heat, shrinking and expanding according to the temperatures. Has to be something better out there Im hoping? Dave
  5. 345202C1-A466-4AED-9BD7-2FF02DA82CB7.jpeg

    345202C1-A466-4AED-9BD7-2FF02DA82CB7.jpeg

  6. F8D61785-844D-4552-B34D-0ABCAAE4EA54.jpeg

    F8D61785-844D-4552-B34D-0ABCAAE4EA54.jpeg

  7. D

    Help/Suggestions for deck drain material.

    Happy Memorial weekend all! We are under construction for a new pool and the deck drain we have installed on the current pool has been nothing short of a trip hazard. Not to mention the shrinking. I am looking for assistance on what is out there to have a better/safer product. Deck length...
  8. D

    Aqualink RS not maintaining spa temperature

    Yes, once the spa reaches the preset temp they both shutoff and do not come back on. More info; Each time this happened I have lnot ooked at the heater itself as I was barefoot, it was night, and I just got out of the warm water. But just now I reactivated the spa via the aqualink and went...
  9. D

    Aqualink RS not maintaining spa temperature

    Thank you Patrick :)
  10. D

    Aqualink RS not maintaining spa temperature

    Good evening, Yet again tonight I had my spa heat to the preset temp of 99 degrees and after it does heat up which takes about 45 minutes, the motor turns off, the red light of the aqualink panel turns green (versus red while it is heating). To this point I believe this is all normal. The...
  11. D

    Confirmation of results/help

    Oh, yes I was. Thank you for the suggestion. Dave
  12. D

    Confirmation of results/help

    Yes sir, I am. We've had some ridiculous winds over the last few weeks, so the vac is running.
  13. D

    Confirmation of results/help

    Thanks all. John, not sure I understood, sorry would you mind please explaining? Duraleigh, I have a pool vac, Hayward pro series. Not sure if that specifically is what you were asking? Thanks all. Dave
  14. D

    Confirmation of results/help

    Ok. Dang that whip hurts;)
  15. D

    Confirmation of results/help

    Hello again, I now have my K-2006 kit. I keep the CL2 levels up above 10ppm as previously stated for about 8-10 days. Again this is a natural rock pool with some inlets and crevices that I guess provide some dead spots and there still is some light algae in these areas. Today's readings...