Recent content by coastal

That may have been the problem. I had to add liquid chlorine because it was too low to do the overnight test. The chlorine level wen down overnight by 2pp. i will add more reinforcements as needed and hopefully the SWG will be able to maintain after killing anything else that’s contributing to...

No I didn’t, I’ll look that up and do that.

Jack's Magic Stain Solution #1, Chlorine-Based Pools the Blue Stuff

I had some staining on my inground pool so I turned my ic30 to 0 to lower the FC level per the instructions for magic jacks. Process went great, the next day stains were gone. then I started the ic30 at 20%, usually sits about 30 or 40% depending on the time of year. FC level didn’t budge, move...

That's great, thanks! I'll reply to your PM.

Yes, I have this wall remote and the screenLogic that I use with my app. I mostly use my app anyway but the wall remote is very handy to turn on the spa and to check water temp. I have the

I have the Pentair Easy Touch model 520614 and I believe its had a stroke. I first realized I had a problem when it mysteriously maxed out the temp in the pool and spa to 104, reset using my phone app but would happen again. Since I removed the wall unit, I haven't had an issue. The display on...

@Jimrahbe , you change the actuator valve position by moving the cam, correct? I will have to move the cam to make the return normal off on spa return instead of the neutral 50/50 position. making the valve a 180* turn The suction side, keep as currently. Thanks Rich

Yep, that’s what I have, found it, thanks. I’ve never been in that section before. Maybe now I can also figure out how to make it so I can change the light colors on my bubblers Thanks, Rich

Thanks for the great detail @Jimrahbe ! I’ll do a search about reconfiguring my return valve, I believe I understand what you mean there, instead of in the center as off, it has to be either all pool or all spa. when I go into my ScreenLogic, I don’t have those setup pages. The only page that...

yes, I have the ScreenLogic app.

I was reading in another thread that you can schedule to only have your spillway run for a few hours rather than all the time. From looking at my system, I don’t think the builder set it up for this feature, and I don’t see an option in the menu. Below I’ve posted some pictures of my system, do...